GAMC #4 - PermaGrin

[PermaGrin]

High Res work in progress

[PermaGrin]

High Res work in progress


Looking to spend another day or so just fiddling and adding more detail. Sorta dont care for how plain the very back end is looking.

[Tiros]

Looking good there permagrin. I don't quite get why you put the holes/vents in the back of the thing though.

Correct me if I'm wrong, but I thought a jet engine was all about air taken in at the front and getting compressed as it moves back, blowing it out at a greater speed compared to when it got in. But right now it'd just blow right out of the vents decreasing the compressing and directional thrust.

And if it now is so that they're not connected to the actual 'barrel' then I simply don't understand what they're doing there

Keep it up, cheers!

[PermaGrin]

TY.

I was going more for more like a heat sink rather than vents.

[urgaffel]

I like it, it's lookig cool. Those heatsinks could be rotating the opposite way of the turbines (if you were to make an animation of it) for a cool effect... More images please

[PermaGrin]

Finished the High Res.



Hope to start/finish the low res (and UV) by the end of tomorrow.

[myles]

Lovely, all those pipes are going to be a nightmare in the low poly.

[Theht]

yes realy crazy stuff with these pipes. hope you will come too finish.

[PermaGrin]

Low Res work in progress


Dont know how much more I will get done tonight, due to football and all.
Depending on how the polycount starts to turn out, I might got back through and trim down the little cylinders on the side by few edges. Also I decided to cut out the little pipes on the bottom and the pipe on the side (one that looks like you can add oil or something into it).

[urgaffel]

Very cool highpoly but yeah, those pipes are going to be a pain. If you're keeping them, you will have to take a few edges out of the cylinders you mention