View Single Post
Old 06-11-2007, 12:09 PM   #5 (permalink)
UnsteadyTeddy
Senior Member
UnsteadyTeddy's User Activity: 0/10
448 - 177
Looks nice junkers.
I'd round out the bottom metally corner bit next to the glassy bit. You could also save more tris on the bottom inside ( plane across for the grey bit, then just a few hexagons intersecting it instead of all the tris in the base ). You could reduce some of the segments on the smaller cylidners on the top and the side.
UnsteadyTeddy is offline   Reply With Quote
The Following User Says Thank You to UnsteadyTeddy For This Useful Post: